Diagnostic Procedures
WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If a fuel trim, HO2S, misfire, system voltage or throttle actuator DTC is also set, diagnose that DTC first. See DIAGNOSTIC TROUBLE CODE DEFINITIONS
.
- Warm engine to more than 176°F (80°C). Turn accessories on to load engine. Using scan tool, perform the following procedure using ENGINE SPEED CONTROL special function while monitoring ENGINE SPEED.
- Command 1600 RPM and hold for 5 seconds.
- Command 1000 RPM and hold for 5 seconds.
- Command 600 RPM and hold for 5 seconds.
- Check the following for possible causes of high idle speed:
- Vacuum leak.
- System voltage out of range.
- ECT skewed.