LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Engine Controls - Self-Diagnostics - 3.0L) >> Diagnostic Tests >> DTC P0156: Ho2S Circuit - Bank 2, Sensor 2 >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition on, engine off. Disconnect HO2S bank 2 sensor 2. Check for corrosion in harness connector. If corrosion is present, clean corrosion out of harness connector and make sure seal is not damaged. If corrosion is not present, go to next step.
  2. Using scan tool, monitor HO2S bank 2 sensor 2. If reading is more than 519 mV, sensor signal wire shorted to voltage. See DTC P0158: HO2S CIRCUIT - HIGH VOLTAGE - BANK 2 SENSOR 2  for diagnosis. If reading is not more than 519 mV, go to next step.
  3. Connect test light between battery voltage and HO2S connector terminal No. 2 (Yellow wire). Using scan tool, monitor HO2S bank 2 sensor 2. If reading is more than 519 mV, repair short between Purple wire and Yellow wire. If reading is not more than 519 mV, replace HO2S bank 2 sensor 2.
scientia non olet · About LEMON Manuals