LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1166 (Manual Transmission - Mm6/M12) >> Repair Instructions >> Gear Select/Skip Shift Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Using the J 41099  , install the gear select (skip shift) solenoid.

    Tighten 

    Tighten the gear select solenoid to 40 N.m (30 lb ft).

    Fig 1: Using J 41099 To Install Gear Select (Skip Shift) Solenoid
    G01971364Courtesy of GENERAL MOTORS CORP.
  2. Connect the gear select solenoid electrical connector.
  3. Lower the vehicle.
    Fig 2: Connecting Gear Select Solenoid Electrical Connector
    G01971365Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals