LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1162 (Engine Mechanical - 5.7L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Coolant Air Bleed Pipe Cleaning and Inspection

Coolant Air Bleed Pipe Cleaning and Inspection

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Do not use the engine coolant air bleed pipe and cover gaskets again. Upon installation of the pipe and covers, install NEW gaskets.

  1. Remove the sealing gaskets from the pipe.
  2. Remove the sealing gaskets from the covers.
    Fig 1: Removing Sealing Gaskets
    G01970993Courtesy of GENERAL MOTORS CORP.
  3. Clean the pipe (1), hose (2), and covers in solvent.
    CAUTION: Refer to SAFETY GLASSES CAUTION .
  4. Dry the pipe and covers with compressed air.
  5. Inspect the pipe and covers for damage or restrictions.
  6. Inspect the gasket and hose sealing surfaces for damage.
  7. Inspect the hose (2) for restrictions, cracking or wear.

    The hose may be used again if it is not damaged.

    Fig 2: Inspecting Pipe And Covers
    G01970994Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals