LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1162 (Engine Mechanical - 5.7L) >> Diagnostic Information and Procedures >> Drive Belt Excessive Wear Diagnosis >> Test Description

Test Description

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The number(s) below refer to the step number(s) on the diagnostic table.

  1. 2. The inspection is to verify that the drive belt(s) is correctly installed over all of the drive belt pulleys. Wear on the drive belt(s) may be caused by mis-positioning the drive belt(s) by one groove on a pulley.
  2. 3. The installation of a drive belt that is to wide or to narrow will cause wear on the drive belt(s). The drive belt ribs should match all of the grooves on the pulleys.
  3. 4. This inspection is to verify the drive belt(s) is not contacting any parts of the engine or body while the engine is operating. There should be sufficient clearance when the drive belt accessory drive components load varies. The drive belt(s) should not come in contact with an engine or a body component when snapping the throttle.
    Fig 1: Diagnostic Symptom Check - Drive Belt Excessive Wear Diagnosis
    G01970352Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals