LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1130 (Engine Mechanical (Repair Instructions 5 Of 5) - 3.6L (Ly7)) >> Repair Instructions (Off-Vehicle Repair Instructions - Part 4) >> Air Conditioning (A/C) Compressor Installation

Air Conditioning (A/C) Compressor Installation

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Follow the procedure sequence in order to prevent drive belt mis-alignment and/or possible damage/distortion to the components.
    Fig 1: Installing Air Conditioning (A/C) Compressor
    GM1395917Courtesy of GENERAL MOTORS CORP.
  1. Place the A/C compressor in position to the cylinder block.
  2. Loosely install the A/C compressor bolts.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the A/C compressor front upper bolt.

    Tighten:  Tighten the A/C compressor front upper bolt to 50 N.m (37 lb ft).

  4. Tighten the A/C compressor rear upper bolt.

    Tighten:  Tighten the A/C compressor rear upper bolt to 50 N.m (37 lb ft).

  5. Tighten the A/C compressor rear lower bolt.

    Tighten:  Tighten the A/C compressor rear lower bolt to 50 N.m (37 lb ft).

  6. Tighten the A/C compressor front lower bolt.

    Tighten:  Tighten the A/C compressor front lower bolt to 22 N.m (16 lb ft).

scientia non olet · About LEMON Manuals