LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1129 (Engine Mechanical (Repair Instructions 4 Of 5) - 3.6L (Ly7)) >> Repair Instructions (Off-Vehicle Repair Instructions - Part 3) >> Thermostat Housing Installation

Thermostat Housing Installation

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Thermostat Housing Gasket
    GM1412155Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW gasket onto the thermostat housing.
    2. Fig 2: Identifying Thermostat Housing Mounting Bolts
    GM1412152Courtesy of GENERAL MOTORS CORP.
  2. Install the thermostat housing.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the thermostat housing bolts.

    Tighten:  Tighten the thermostat housing bolts to 10 N.m (89 lb in).

    4. Fig 3: Installing Heater Inlet/Outlet Pipe Assembly Gasket And O-Ring
    GM1412151Courtesy of GENERAL MOTORS CORP.
  4. Install a NEW gasket and O-ring onto the heater inlet/outlet pipe assembly.
    5. Fig 4: View Of Heater Inlet/Outlet Pipe Assembly
    GM1412150Courtesy of GENERAL MOTORS CORP.
  5. Install the heater inlet/outlet pipe assembly.
  6. Install the heater inlet/outlet pipe assembly bolts.

    Tighten:  Tighten the heater inlet/outlet pipe assembly bolts to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals