Engine Front Cover Assemble

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

EN 46103 Camshaft Actuator Valve Seal Remover/Installer
J 29184 Output Shaft Seal Installer

Fig 1: Installing Crankshaft Front Oil Seal

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal.

Install the NEW crankshaft front oil seal into the engine front cover using the J 29184 .

Fig 2: Installing camshaft position actuator valve oil seals

Courtesy of GENERAL MOTORS CORP.

Install the NEW camshaft position actuator valve oil seals into the engine front cover using the EN 46103 .