LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1125 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Heater Hose Replacement - Inlet (LA1) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.
  2. Remove the wiper motor module assembly. Refer to Wiper Motor Module Replacement in Wipers/Washer Systems.
  3. Disconnect the vacuum hose from the brake booster and reposition.
  4. Remove the air cleaner cover and intake tube. Refer to Air Cleaner Intake Duct Replacement in Engine Controls - 3.4 L.
    5. IMPORTANT: Disconnect the throttle and cruise control cables from the TBI mounting bracket to prevent bending the cable housings.
  5. Disconnect the throttle and cruise control cables.
  6. Remove the transmission fluid filler tube. Refer to Fluid Filler Tube Replacement (LA1) or Fluid Filler Tube Replacement (LY7) in Automatic Transaxle - 4T65-E.
    7. Fig 1: View Of Heater Hose Pipe Connections
    GM395311Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the inlet heater hose (1) from the inlet heater pipe (2).
    8. Fig 2: Locating Heater Hoses
    GM819323Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the heater hose clamp using the J 38185  .
  9. Disconnect the inlet heater hose from the heater core.
  10. Remove the inlet heater hose.
scientia non olet · About LEMON Manuals