Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.6L.
- Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging .
- Remove the nut that secures the discharge hose to the condenser.
- Disconnect the discharge hose from the condenser.
- Cap or tape the discharge port on the condenser.
- Remove the nut that secures the discharge hose to the compressor.
- Disconnect the discharge hose from the compressor.
- Cap or tape the compressor discharge port.
- Remove the discharge hose.
- Remove and discard the sealing washers.
IMPORTANT:
Cap or tape the open A/C components immediately to prevent A/C system contamination.