LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1125 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Resistor Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right side instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
    2. Fig 1: Blower Motor & Electrical Connector
    GM295327Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the blower motor electrical connector.
  3. Remove the blower motor mounting screws.
  4. Remove the blower motor from the HVAC module assembly.
    5. Fig 2: Locating Electrical Connector From The Blower Motor Resistor
    GM295302Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector from the blower motor resistor assembly.
    6. IMPORTANT: Only loosen both of the forward blower resistor assembly mounting screws. The blower motor resistor assembly mounting holes are slotted.
  6. Loosen the forward blower resistor assembly mounting screws.
  7. Remove the rearward blower resistor assembly mounting screw.
    8. Fig 3: View Of Blower Motor Resistor Assembly
    GM295304Courtesy of GENERAL MOTORS CORP.
  8. Remove the blower motor resistor assembly from the HVAC module assembly.
scientia non olet · About LEMON Manuals