LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Engine Controls Self-Diagnostics) >> Diagnostic Tests >> DTC P0601-P0607, P1600, P1621, P1627, P1680, P1681 & P1683: Pcm Memory >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the Diagnostic System Check-Engine Controls? If yes, go to next step. If no, see DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM.
  2. Is DTC P0602 set? If yes, go to next step. If no, go to step  5.
  3. Program the PCM. See POWERTRAIN CONTROL MODULE  under PROGRAMMING. Does DTC P0602 reset? If yes, go to next step. If no, go to step  6.
  4. Ensure that all tool connections are secure. Ensure that the programming equipment is operating correctly. Ensure that the correct software/calibration package is used. Attempt to program the PCM. See POWERTRAIN CONTROL MODULE  under PROGRAMMING. Does DTC P0602 reset? If yes, go to next step. If no, go to step  6.
  5. Replace the PCM. See appropriate REMOVAL, OVERHAUL & INSTALLATION article. Reprogram PCM. See POWERTRAIN CONTROL MODULE  under PROGRAMMING. After repairs, go to next step.
  6. Clear the DTCs with a scan tool. Turn OFF the ignition for 30 seconds. Start the engine. Did the DTC fail this ignition cycle? If yes, go to step  2. If no, go to next step.
  7. Observe the stored information, Capture Info with a scan tool. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
scientia non olet · About LEMON Manuals