Ride Diagnosis
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Ride Diagnosis
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the General Description and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Suspension General Diagnosis |
| 2 |
IMPORTANT:
Verify the vehicle suspension package RPO. Verify that the ride is too soft or too hard.Does the vehicle ride normally? |
System OK | Go to Step 3 |
| 3 | Check the tire inflation and adjust to specifications. Refer to Tire Inflation Description
in Maintenance and Lubrication. Did you adjust the tire pressure? |
Go to Step 7 | Go to Step 4 |
| 4 | Inspect the vehicle trim height. Refer to Trim Height Inspection Procedure
. Did you find and correct the condition? |
Go to Step 7 | Go to Step 5 |
| 5 | Inspect the following suspension components for wear or damage.
Did you find and correct the condition? |
Go to Step 7 | Go to Step 6 |
| 6 | If equipped with the automatic level control system refer to Diagnostic Starting Point - Automatic Level Control
in Automatic Level Control. Do you have and perform a special ride package procedure? |
Go to Step 7 | System OK |
| 7 | Drive the vehicle in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |