LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1114 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Oil Pan Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transaxle Oil Pan And Gasket
    GM164804Courtesy of GENERAL MOTORS CORP.
  1. Install the oil pan gasket (25).
  2. Install the oil pan (24).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the oil pan bolts (23).

    Tighten:  Tighten the oil pan bolts (23) to 14 N.m (10 lb ft).

  4. Lower the vehicle.
  5. Fill the transaxle with the proper quantity of DEXRON® III.
  6. Place the gear selector in the Park position.
  7. Start the engine.
  8. Run the engine at a slow idle. Do NOT race the engine.
    9. NOTE: Do NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the transaxle.
  9. Adjust the fluid level. Refer to Transmission Fluid Checking Procedure , Capacities - Approximate Fluid and Fluid and Lubricant Recommendations in Maintenance and Lubrication.
  10. Inspect for proper completion of the repairs.
  11. Inspect the fluid for leaks.
scientia non olet · About LEMON Manuals