LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1114 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Range Selector Cable Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Automatic Transaxle Range Selector Lever Retaining Nut
    GM629693Courtesy of GENERAL MOTORS CORP.
  1. Install the automatic transaxle range selector lever to the automatic transaxle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the automatic transaxle range selector lever retaining nut.

    Tighten:  Tighten the automatic transaxle range selector lever retaining nut to 20 N.m (15 lb ft).

    3. Fig 2: Identifying Automatic Transaxle Range Selector Cable To Cable Bracket
    GM629687Courtesy of GENERAL MOTORS CORP.
  3. Install the automatic transaxle range selector lever cable to the automatic transaxle range selector lever.
  4. Adjust the automatic transaxle range selector lever cable if necessary. Refer to Automatic Transmission Range Selector Cable Adjustment .
  5. Install the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Engine Controls-3.4L.
scientia non olet · About LEMON Manuals