LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1114 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transaxle mount bracket.
    2. Fig 1: View Of Transaxle Mount Bracket And Bolts
    GM161246Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the transaxle mount bracket bolts.

    Tighten:  Start with the forward lower bolt and work clockwise to tighten the transaxle mount bracket bolts to 95 N.m (70 lb ft).

  3. Remove the utility stand.
    4. Fig 2: View Of Transaxle Mount Upper Nuts
    GM368791Courtesy of GENERAL MOTORS CORP.
  4. Install the transaxle mount upper nuts.

    Tighten:  Tighten the transaxle mount upper nuts to 47 N.m (35 lb ft).

  5. Install the left engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
  6. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals