LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1111 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Right Front (Pontiac) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat belt retractor into the T-slot in the center pillar.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the seat belt retractor bolt.

    Tighten:  Tighten the seat belt retractor bolt to 42 N.m (31 lb ft).

  3. Install the seat belt intermediate guide to the center pillar.
    4. Fig 1: View Of Seat Belt Retractor Bolt
    GM620831Courtesy of GENERAL MOTORS CORP.
  4. Install the seat belt intermediate guide bolts.

    Tighten:  Tighten the seat belt intermediate guide bolts to 10 N.m (89 lb in).

  5. Place the anchor plate to the seat stud.
  6. Install the anchor plate nut to the seat stud.

    Tighten:  Tighten the anchor plate nut to 42 N.m (31 lb ft).

  7. Install the center pillar lower trim. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  8. Place the seat belt guide loop to the guide adjuster bracket.
    9. Fig 2: Locating Seat Belt Guide Loop
    GM620836Courtesy of GENERAL MOTORS CORP.
  9. Install the nut to the seat belt guide loop.

    Tighten:  Tighten the seat belt guide loop nut to 42 N.m (31 lb ft).

  10. Close the seat belt guide loop cover.
scientia non olet · About LEMON Manuals