Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Shock Absorber Upper Bolt And Nut (Front Wheel Drive)

Courtesy of GENERAL MOTORS CORP.

Install the shock absorber.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the shock absorber bolts and nuts.
Tighten: Tighten the shock absorber nuts to 85 N.m (63 lb ft).
If the vehicle is equipped with automatic level control, install the air tube connector to the shock absorber.
Remove the utility stand from the rear axle.
Lower the vehicle.