Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Install the coil spring (2).
- Use the utility jack in order to raise the lower control arm and load the suspension.
- Use the J 41820 in order to connect the ball joint to the knuckle.
- Install the stabilizer link to the lower control arm.
- Use the utility jack in order to support the lower control arm.
- Install the ABS electrical connector mounting bracket.
- Connect the ABS electrical connector.
- Install the brake caliper mounting bracket.
- Install the parking brake cable mounting bracket.
- Install the brake calipers. Refer to Brake Caliper Replacement - Rear in Disc Brakes.
- Install the wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.