Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Siphon the power steering fluid from the reservoir.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the inner fender liner enough to gain access to the front frame bolts. Refer to Front Fender Liner Replacement in Exterior Trim.
- Lower the vehicle to allow a floor jack to engage with the frame.
- Use a floor jack in order to support the frame and the powertrain.
- Remove the right side frame-to-body bolts.
- Use the floor jack to lower the right side of the frame and powertrain to provide clearance to the back of the reservoir.
- Disconnect the engine control module (ECM) wire harness from the ECM wire harness clip on the reservoir.
- Remove the power steering pressure pipe/hose from the power steering reservoir bracket. Refer to Power Steering Pressure Pipe/Hose Replacement (LA1) or Power Steering Pressure Pipe/Hose Replacement (LY7) .
- Remove the power steering reservoir mounting stud bolt.
- Turn the reservoir to provide visual access to the reservoir hoses.
- Disconnect the power steering pump inlet hose from the power steering reservoir.
- Disconnect the power steering return hose from the power steering reservoir.
- Remove the power steering reservoir and bracket from the vehicle.
- Cap off the power steering reservoir and hoses to prevent contamination.
- Remove the ECM retaining clip from the reservoir.
- Remove the power steering reservoir bracket from the reservoir. Refer to Remote PS Fluid Reservoir Bracket Replacement (LY7) .