LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1095 (Engine Mechanical - 3.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Pump Drive Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Drive
    GM187033Courtesy of GENERAL MOTORS CORP.
  1. Apply prelube GM P/N 1052365 or the equivalent to the oil pump drive gear.
  2. Apply engine oil to the oil pump drive gear assembly for ease of assembly.
  3. Install the oil pump drive gear assembly.
  4. Install the oil pump drive gear clamp.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the oil pump drive gear clamp bolt.

    Tighten:  Tighten the oil pump drive gear clamp bolt to 36 N.m (27 lb ft).

  6. Connect the fuel feed and return pipe to the fuel injector rail. Refer to Fuel Hose/Pipes Replacement - Engine Compartment in Engine Controls - 3.4L.
  7. Install the upper intake manifold. Refer to Intake Manifold Replacement - Upper .
scientia non olet · About LEMON Manuals