LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1095 (Engine Mechanical - 3.4L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Level Indicator & Oil Level Indicator Tube
    GM187069Courtesy of GENERAL MOTORS CORP.
  1. Install the oil level indicator and oil level indicator tube.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the oil level indicator tube bolt.

    Tighten:  Tighten the oil level indicator tube bolt to 25 N.m (18 lb ft).

  3. Install the thermostat bypass pipe (3).
    4. Fig 2: Thermostat Bypass Pipe & Components
    GM660211Courtesy of GENERAL MOTORS CORP.
  4. Install the thermostat bypass pipe (3) and hose clamp (5).
  5. Install the thermostat bypass pipe to engine front cover bolt (4).

    Tighten:  Tighten the thermostat bypass pipe to engine front cover bolt to 11 N.m (98 lb in).

  6. Install the thermostat bypass pipe (3) to throttle body hose clamps (1).
  7. Install the thermostat bypass pipe to throttle body nut (2).

    Tighten:  Tighten the thermostat bypass pipe to throttle body nut to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals