LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1094 (Engine Mechanical (Repair Instructions 1 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 1) >> Engine Mount Strut Bracket Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the right engine mount strut bracket to the vehicle.
    2. Fig 1: Locating Engine Mount Strut Bracket Bolts
    GM1457532Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Connect the engine mount strut bracket bolts to the cylinder head.

    Tighten:  Tighten the engine mount strut bracket bolts to 50 N.m (37 lb ft).

  3. Install the generator into the proper position.
  4. Install the generator bolts.

    Tighten:  Tighten the generator bolts to 50 N.m (37 lb ft).

  5. Install the right engine mount strut and radiator support bracket to the right engine mount strut bracket. Refer to Engine Mount Strut Replacement - Right .
  6. Connect the pulley to the generator.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (LY7) in Engine Electrical.
scientia non olet · About LEMON Manuals