LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1094 (Engine Mechanical (Repair Instructions 1 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 1) >> Cylinder Head Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. If necessary, perform the following steps:
    2. Fig 1: View Of Left Cylinder Head Gasket
    GM902814Courtesy of GENERAL MOTORS CORP.
  2. Install a NEW cylinder head gasket.
    3. Fig 2: View Of Left Cylinder Head
    GM902815Courtesy of GENERAL MOTORS CORP.
  3. Carefully install the cylinder head with the exhaust manifold to the engine. Refer to Cylinder Head Installation - Left .
    4. IMPORTANT: Do not remove the exhaust crossover pipe.
  4. Connect the exhaust crossover pipe to the left bank exhaust manifold. Refer to Exhaust Crossover Pipe Replacement (LY7) in Engine Exhaust.
    5. Fig 3: Locating Coolant Temperature Sensor Electrical Connector
    GM1394058Courtesy of GENERAL MOTORS CORP.
  5. Install the coolant temperature sensor electrical connector heat shield.
  6. Install the oil level indicator. Refer to Oil Level Indicator and Tube Replacement .
  7. Install the left bank secondary timing chain. Refer to Secondary Camshaft Drive Chain Replacement - Left .
  8. Install the generator. Refer to Generator Replacement (LY7) in Engine Electrical.
  9. Install the assembled powertrain module to the vehicle. Refer to Engine Replacement .
scientia non olet · About LEMON Manuals