LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1094 (Engine Mechanical (Repair Instructions 1 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 1) >> Camshaft Cover Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a NEW camshaft cover seal and NEW grommets.
    2. Fig 1: Removing & Installing Camshaft Cover
    GM902873Courtesy of GENERAL MOTORS CORP.
  2. Install the camshaft cover. Refer to Camshaft Cover Installation - Right .
    3. Fig 2: Ignition Coil View
    GM860797Courtesy of GENERAL MOTORS CORP.
  3. Install the ignition coils.
    4. Fig 3: Identifying Wiring Harness On Camshaft Cover
    GM1394030Courtesy of GENERAL MOTORS CORP.
  4. Install the wiring harness to the front of the camshaft cover.
  5. Install the wiring harness conduit retainers to the wiring harness conduit.
    6. Fig 4: View Of Wiring Conduit Retainers
    GM1394034Courtesy of GENERAL MOTORS CORP.
  6. Install the wiring harness to the side of the camshaft cover.
    7. Fig 5: Locating Ignition Coil Electrical Connectors
    GM1394028Courtesy of GENERAL MOTORS CORP.
  7. Connect the ignition coil electrical connectors.
  8. Install the upper intake manifold with the lower intake manifold. Refer to Intake Manifold Replacement - Lower .
scientia non olet · About LEMON Manuals