LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1093 (Frame And Underbody) >> Repair Instructions >> Frame Cushion or Insulator Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the front frame insulator opening.
  2. Apply a thin coat of rubber lubricant GM P/N 1051717, Canadian P/N 5728223, or equivalent to the inside of the front frame insulator opening.
  3. Apply a thin coat of rubber lubricant GM P/N 1051717, Canadian P/N 5728223, or equivalent to the front frame insulator.
    4. Fig 1: Aligning The Front Frame Insulator
    GM777205Courtesy of GENERAL MOTORS CORP.
  4. Align the front frame insulator to the front frame opening with the front frame alignment tabs facing to the front.
  5. Using J 45296  , install the front frame insulator to the front frame. See Special Tools and Equipment .
    6. Fig 2: View Of Front Frame Bolts And Retainers
    GM319188Courtesy of GENERAL MOTORS CORP.
  6. Install the frame front upper insulators.
  7. Raise the front of the frame.
    8. NOTE: Refer to Fastener Notice in Cautions and Notices.
  8. Install the front frame bolts and retainers.

    Tighten:  Tighten the front frame bolts to 155 N.m (114 lb ft).

  9. Remove the jackstand.
  10. Connect the steering intermediate shaft. Refer to Intermediate Steering Shaft Replacement in Steering Wheel and Column.
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals