LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1088 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Quarter >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the push-in retainer nuts to the D-pillar, if required.
    Fig 1: Identifying D-Pillar Push-In Retainer Nuts
    GM618023Courtesy of GENERAL MOTORS CORP.
  2. Use a heat gun J 25070  .
    IMPORTANT: Do not touch the adhesive backing on the molding.
  3. Remove the protective liner from the back side of the rear quarter panel molding.
  4. Position the rear quarter panel molding to the rear quarter panel.
  5. Install rear quarter panel molding starting at the D-pillar and working forward and locating the push-in retainers to the rear quarter panel, pressing rear quarter panel molding into place until fully seated.
    Fig 2: Locating Rear Quarter Panel Molding Retainers
    GM621015Courtesy of GENERAL MOTORS CORP.
  6. Install the upper edge of the rear quarter panel molding by applying pressure to the entire length of the molding starting at the rear and working forward in order to ensure a maximum bond to the rear quarter panel.
  7. Install the push-in retainers to the inside rear edge of the rear quarter panel molding.
    Fig 3: Locating Rear Quarter Panel Molding Push-In Retainers
    GM621014Courtesy of GENERAL MOTORS CORP.
  8. Close the endgate.
scientia non olet · About LEMON Manuals