LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1088 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Liftgate Upper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lift gate applique. Refer to Liftgate Applique Replacement in Body Rear End.
  2. Remove the lift gate handle. Refer to Handle Replacement - Endgate in Body Rear End.
  3. Remove the lift gate lower molding. Refer to Molding Replacement - Liftgate Lower .
  4. Remove the screws from the lift gate upper molding.
    Fig 1: Locating Lift Gate Upper Molding Screws
    GM851577Courtesy of GENERAL MOTORS CORP.
  5. Remove the lift gate upper molding from the lift gate.
    Fig 2: Removing Lift Gate Upper Molding
    GM851580Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals