LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1088 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Front Wheel Opening (Aztek) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the molding to the fender.
  2. Align the push-in retainers to the holes in the fender.
    Fig 1: Identifying Wheel Opening Molding (Aztek)
    GM621008Courtesy of GENERAL MOTORS CORP.
  3. Press the molding to the fender until all of the retainers are fully seated.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screws to the front wheel opening molding.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    Fig 2: View Of Front Wheel Opening Molding Screws (Aztek)
    GM618031Courtesy of GENERAL MOTORS CORP.
  5. Install the bolts to the corner of the front fascia. Refer to Fascia Replacement - Front Bumper - Upper (Aztek) or Fascia Replacement - Front Bumper - Upper (Rendezvous) in Bumpers.
  6. Install the front wheel liner. Refer to Front Fender Liner Replacement in Body Front End.
scientia non olet · About LEMON Manuals