Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Apply masking tape to the area around the hood emblem to protect the finish.
Open the hood.
Remove the nuts from the back of the hood emblem.

Fig 1: Locating Hood Emblem Mounting Nuts
Courtesy of GENERAL MOTORS CORP.
To remove the emblem from the hood, heat the emblem using the J 25070 152 mm (6.0 in) from the surface.
Apply heat in a circular motion for about 30 seconds.
NOTE: Refer to Exterior Trim Emblem Removal Notice in Cautions and Notices.
Use a plastic, flat bladed tool to lift or remove the emblem from the hood.
Remove any adhesive from the hood using a 3M™ Scotch Brite molding adhesive remover disk P/N 07501 or equivalent.

Fig 2: Adhesive Removal Tool
Courtesy of GENERAL MOTORS CORP.