LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1083 (Bumper System) >> Repair Instructions >> Fascia Replacement - Rear Bumper (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the energy absorber to the rear fascia.
  2. Install the rear parking assist object sensor to the rear bumper fascia. Refer to Rear Object Sensor Replacement in Rear Parking Assist.
  3. Partially install the rear bumper fascia.
  4. Connect the rear parking assist electrical connector.
    Fig 1: Identifying Rear Parking Assist Electrical Connector (Rendezvous)
    GM754688Courtesy of GENERAL MOTORS CORP.
  5. Position the rear bumper fascia to the vehicle.
  6. Engage the ball stud on each side of the rear bumper fascia.
    Fig 2: Locating Ball Stud On Rear Bumper Fascia (Rendezvous)
    GM754747Courtesy of GENERAL MOTORS CORP.
  7. Starting at the center hole, install the push-in retainers to the lower rear bumper fascia.
    Fig 3: Identifying Rear Bumper Fascia Push-In Retainers To The Rear Impact Bar (Rendezvous)
    GM754680Courtesy of GENERAL MOTORS CORP.
  8. Install the push-in retainers to the rear bumper fascia upper tabs.
  9. Install the screws to the rear bumper fascia at the inboard side of the rear quarter panel.
    Fig 4: View Of RH/LH Rear Bumper Fascia Screws (Rendezvous)
    GM754685Courtesy of GENERAL MOTORS CORP.
  10. Close the endgate.
scientia non olet · About LEMON Manuals