LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1075 (Garage Door Opener System) >> Diagnostic Information and Procedures >> Garage Door Opener Inoperative

Garage Door Opener Inoperative

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Garage Door Opener Inoperative

Step Action Yes No
1 Did you review the Garage Door Opener Description and Operation and perform the necessary inspections? Go to Step 2  Go to Garage Door Opener Description and Operation 
2
IMPORTANT: If the vehicle is equipped with a valet switch, verify that the switch is in the OFF position.
Operate each button on the garage door opener one at a time.Do all 3 buttons illuminate the LED?
Go to Step 4  Go to Step 3 
3 Do any buttons illuminate the LED? Go to Step 9  Go to Step 5 
4
  1. Place the J 41540  HomeLink Tester, adjacent to the GDO as indicated. See Special Tools and Equipment .
  2. Operate each button on the garage door opener.
Does the J 41540  verify each button when pressed? See Special Tools and Equipment .
Go to Step 9  Go to Step 8 
5 Test the Switched Ignition Voltage circuit for an open, high resistance or a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 11  Go to Step 6 
6 Test the Inadvertent Power Supply circuit for an open, high resistance or short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 11  Go to Step 7 
7 Test the ground circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 11  Go to Step 8 
8 Inspect for poor connection at the harness connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 11  Go to Step 9 
9 Replace the garage door opener.
Did you complete the replacement?
Go to Step 10 
10 Program the garage door opener. Refer to Garage Door Opener Programming - Universal .
Did you complete the procedure?
Go to Step 11 
11 Operate the system in order to verify the repair.
Does the garage door opener operate properly for the customer?
System OK Advise the customer to call HomeLink™ at 1-800-355-3515