LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1073 (Engine Controls - 3.4L - Introduction - Service & Replacement) >> Repair Instructions >> Fuel Level Sensor Replacement (Prior to VIN 4S558922 (100mm Sender)) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Tank Pressure Sensor
    GM682671Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement (Prior to VIN 4S558922 (100mm Sender)) Fuel Sender Assembly Replacement (VIN 4S558922 and Later (130mm Sender)) .
  2. Disconnect the fuel pump electrical connector (2).
  3. Remove the fuel level sensor electrical connector retaining clip (4).
  4. Disconnect the fuel level sensor electrical connector from under the fuel sender cover (5).
  5. Remove the fuel level sensor retaining clip.
  6. Squeeze the locking tangs and remove the fuel level sensor (3) from the modular fuel sender.
scientia non olet · About LEMON Manuals