LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1071 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Evaporative Emission (EVAP) Canister Vent Solenoid Valve
    GM1396038Courtesy of GENERAL MOTORS CORP.
  1. Slide the EVAP canister vent solenoid on the EVAP canister vent bracket until the solenoid snaps into place.
  2. Connect the EVAP vent hose to the EVAP canister vent solenoid.
  3. Connect the EVAP canister vent solenoid harness connector.
  4. Install the fuel tank. Refer to Fuel Tank Replacement (Prior to VIN 4S558922 (100mm Sender)) or Fuel Tank Replacement (VIN 4S558922 and Later (130mm Sender)) .
scientia non olet · About LEMON Manuals