LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1071 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement - Bank 2 (Left) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
    2. Fig 1: Locating Camshaft Position (CMP) Sensor Electrical Connector
    GM1394061Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the camshaft position (CMP) sensor electrical connector (1).
    3. Fig 2: Identifying CMP Sensor Bolt
    GM1395984Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
scientia non olet · About LEMON Manuals