LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1071 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement - Bank 1 (Right) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
    2. Fig 1: View Of Camshaft Position (CMP) Sensor Electrical Connector
    GM1394032Courtesy of GENERAL MOTORS CORP.
  2. Remove the power steering pressure hose bracket nut and reposition the hose as necessary in order to gain access. Refer to Power Steering Pressure Pipe/Hose Replacement (LA1) or Power Steering Pressure Pipe/Hose Replacement (LY7) in Power Steering System.
  3. Disconnect the camshaft position (CMP) sensor electrical connector (2).
    4. Fig 2: Locating CMP Sensor Bolt
    GM1395982Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP sensor bolt.
  5. Remove the CMP sensor.
scientia non olet · About LEMON Manuals