LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1071 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement - Bank 1 (Right) Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
  2. Remove the power steering pressure hose bracket nut and reposition as necessary, in order to gain access. Refer to Power Steering Pressure Pipe/Hose Replacement (LA1) or Power Steering Pressure Pipe/Hose Replacement (LY7) in Power Steering System.
    3. Fig 1: View Of Camshaft Position (CMP) Sensor Electrical Connector
    GM1394032Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the camshaft position (CMP) sensor electrical connector (1).
    4. Fig 2: Identifying CMP Sensor Bolt
    GM1395983Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP sensor bolt.
  5. Remove the CMP sensor.
scientia non olet · About LEMON Manuals