LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1071 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Actuator Solenoid Replacement - Bank 2 (Left) Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating CMP Actuator Valve Bolt
    GM1395980Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP actuator valve.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CMP actuator valve bolt.

    Tighten:  Tighten the CMP actuator valve bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Camshaft Position (CMP) Actuator Valve Electrical Connector
    GM1394071Courtesy of GENERAL MOTORS CORP.
  3. Connect the CMP actuator valve electrical connector (2).
scientia non olet · About LEMON Manuals