LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1071 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Actuator Solenoid Replacement - Bank 1 (Right) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
  2. Remove the power steering pressure hose bracket and reposition the hose as necessary in order to gain access. Refer to Power Steering Pressure Pipe/Hose Replacement (LA1) or Power Steering Pressure Pipe/Hose Replacement (LY7) in Power Steering System.
    3. Fig 1: Identifying Camshaft Position (CMP) Actuator Valve Electrical Connector
    GM1394070Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the camshaft position (CMP) actuator valve electrical connector (1).
    4. Fig 2: View Of CMP Actuator Valve Bolt
    GM1395975Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP actuator valve bolt.
  5. Remove the CMP actuator valve.
scientia non olet · About LEMON Manuals