LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1071 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Actuator Solenoid Replacement - Bank 1 (Right) Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating CMP Actuator Valve Bolt
    GM1395977Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP actuator valve.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CMP actuator valve bolt.

    Tighten:  Tighten the CMP actuator valve bolt to 10 N.m (89 lb in).

    3. Fig 2: Identifying Camshaft Position (CMP) Actuator Valve Electrical Connector
    GM1394070Courtesy of GENERAL MOTORS CORP.
  3. Connect the CMP valve electrical connector (2).
  4. Install the power steering pressure hose bracket and nut as necessary. Refer to Power Steering Pressure Pipe/Hose Replacement (LA1) or Power Steering Pressure Pipe/Hose Replacement (LY7) in Power Steering System.
scientia non olet · About LEMON Manuals