Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the electrical connectors to the trim plate.
- Install the trim plate assembly.
- Install the trim plate screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).
- Install the cup liners.
- Install the power accessory liners.
- Close the armrest cover.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.