Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear quarter trim panel to the vehicle.
- Install the cargo net tie-down loops to the rear quarter trim panel. Secure the loops with bolts.
Tighten: Tighten the bolts to 6 N.m (53 lb in).
- Install the upper trim panels. Refer to Trim Panel Replacement - Rear Quarter Upper (Aztek) or Trim Panel Replacement - Rear Quarter Upper (Rendezvous) .
- Install the seat belt guide loops to the rear seat and to the rear No. 2 seat. Refer to Seat Belt Retractor Replacement - Rear and to Seat Belt Retractor Replacement - No. 2 Rear in Seat Belts.
- Install the rear No. 2 seat. Refer to Seat Replacement - Rear No. 2 (Buick) in Seats.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.