Power Mirrors - Mirror Tilt Inoperative in Reverse
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Power Mirrors - Mirror Tilt Inoperative in Reverse
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Outside Mirror Schematics Connector End View Reference: Power Door Systems Connector End Views or Power Seat Systems Connector End Views |
|||
| 1 | Did you perform the Door Systems Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Door Systems |
| 2 | Verify that the power mirrors mirror tilt in reverse fault is present. Does the mirror tilt in reverse operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | Verify that the tilt mirror option is ON. Refer to Driver Personalization
in Personalization. Is the tilt mirror option ON? |
Go to Step 4 | Go to Driver Personalization in Personalization |
| 4 | Do the power mirrors operate properly? | Go to Step 5 | Go to Power Mirrors Inoperative (Aztek) or Power Mirrors Inoperative (Rendezvous w/o A43) or Power Mirrors Inoperative (Rendezvous w/A43) |
| 5 | Inspect for poor connections at the harness connector of the memory seat module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 7 | Go to Step 6 |
| 6 | Replace the memory seat module. Refer to Memory Seat Control Module Replacement
. Did you complete the replacement? |
Go to Step 7 | - |
| 7 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |