LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1032 (Engine Mechanical - 6.6L (Lb7) (Repair Instructions 2 Of 4)) >> Repair Instructions (Off-Vehicle - Part 2) >> Engine Front Cover Removal

Engine Front Cover Removal

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required 

J 37228  Seal Cutter

  1. Remove the crankshaft position sensor bolt.
  2. Remove the crankshaft position sensor.
  3. Remove the crankshaft position sensor spacer bolts.
  4. Remove the crankshaft position sensor spacer.
  5. Remove the O-rings from the crankshaft position sensor and spacer and discard.
    6. Fig 1: View Of Crankshaft Position Sensor, Spacer & Bolts
    GM663804Courtesy of GENERAL MOTORS CORP.
  6. Remove the engine front cover bolts.
  7. Separate the engine front cover from the cylinder block using J 37228  .
  8. Remove the engine front cover.
    9. Fig 2: View Of Engine Front Cover & Bolts
    GM660535Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals