LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1030 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 2 Of 3)) >> Repair Instructions (Off-Vehicle Repair Instructions Part 2) >> Valve Rocker Arm Cover Removal - Left

Valve Rocker Arm Cover Removal - Left

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Do not remove the ignition coils and bracket from the valve rocker arm cover unless required.
  1. Remove the ignition coil bracket bolts from the rocker arm cover, if required.
  2. Remove the ignition coil and bracket assembly from the cover.
  3. Fig 1: View Of Ignition Coil, Bracket Assembly, Wire Harness & Bolts (Left)
    GM1342458Courtesy of GENERAL MOTORS CORP.
  4. Remove the valve rocker arm cover bolts.
  5. Remove the valve rocker arm cover.
  6. Fig 2: View Of Valve Rocker Arm Cover
    GM1277108Courtesy of GENERAL MOTORS CORP.
  7. Remove the gasket (504) from the left cover.
  8. Fig 3: View Of Valve Rocker Arm Cover Gasket
    GM1272820Courtesy of GENERAL MOTORS CORP.
  9. Discard the gasket.

    The bolt grommets may be used again if they are not damaged.