LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1030 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 2 Of 3)) >> Repair Instructions (Off-Vehicle Repair Instructions Part 2) >> Camshaft Removal

Camshaft Removal

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshaft position (CMP) sensor bolt and the sensor.
    2. Fig 1: View Of Camshaft Position (CMP) Sensor & Bolt
    GM260128Courtesy of GENERAL MOTORS CORP.
  2. Remove the camshaft retainer bolts and the retainer.
    3. Fig 2: View Of Camshaft Retainer Plate
    GM63211Courtesy of GENERAL MOTORS CORP.
    NOTE: All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.
  3. Remove the camshaft.
    1. Install the 3 M8 - 1.25 x 100 mm bolts in the camshaft front bolt holes.
    2. Using the bolts as a handle, carefully rotate and pull the camshaft out of the engine block.
    3. Remove the bolts from the front of the camshaft.
    4. Fig 3: View Of Bolts installed In Camshaft Front Bolt Holes
    GM63212Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals