LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1029 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 3 Of 3)) >> Repair Instructions (Off-Vehicle Repair Instructions Part 3) >> Throttle Body Installation

Throttle Body Installation

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the throttle body studs, if required.

    Tighten:  Tighten the throttle body studs to 6 N.m (53 lb in).

    2. IMPORTANT: DO NOT use the throttle body gasket again. Install a NEW gasket during assembly.
  2. Install the throttle body gasket (509) to the intake manifold.
    3. Fig 1: View Of Throttle Body Gasket
    GM1277091Courtesy of GENERAL MOTORS CORP.
  3. Install the throttle body and nuts.

    Tighten:  Tighten the throttle body nuts to 10 N.m (89 lb in).

    4. Fig 2: View Of Throttle Body & Nuts
    GM825837Courtesy of GENERAL MOTORS CORP.
  4. Install the engine coolant air bleed hose and clamp to the throttle body.
scientia non olet · About LEMON Manuals