LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1029 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 3 Of 3)) >> Repair Instructions (Off-Vehicle Repair Instructions Part 3) >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the O-ring seal for cuts or damage. If the oil level indicator tube O-ring seal is not cut or damaged, it may be reused.
  2. Lubricate the O-ring seal with clean engine oil.
  3. Install the O-ring seal onto the oil level indicator tube.
  4. Install the oil level indicator tube into the engine block and rotate into proper position.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the tube bolt.

    Tighten:  Tighten the oil level indicator tube bolt to 25 N.m (18 lb ft).

  6. Install the oil level indicator into the tube.
    7. Fig 1: View Of Oil Level Indicator, Tube & Bolt
    GM260114Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals