LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1029 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 3 Of 3)) >> Repair Instructions (Off-Vehicle Repair Instructions Part 3) >> Coolant Air Bleed Pipe Cleaning and Inspection

Coolant Air Bleed Pipe Cleaning and Inspection

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Do not use the engine coolant air bleed pipe and cover gaskets again. Upon installation of the pipe and covers, install NEW gaskets.
  1. Remove the sealing gaskets from the pipe.
  2. Remove the sealing gaskets from the covers.
    3. Fig 1: View Of Air Bleed Pipe Sealing Gasket
    GM64262Courtesy of GENERAL MOTORS CORP.
  3. Clean the pipe (307), hose (311), and covers in solvent.
    4. Fig 2: View Of Engine Coolant Air Bleed Pipe, Hose & Clamps
    GM1277104Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
  4. Dry the pipe and covers with compressed air.
  5. Inspect the pipe and covers for damage or restrictions.
  6. Inspect the gasket and hose sealing surfaces for damage.
  7. Inspect the hose (311) for restrictions, cracking or wear.

    The hose may be used again if it is not damaged.

scientia non olet · About LEMON Manuals