Clutch Pilot Bearing Installation (without RPO HP2)

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 38836 Bushing Installer and Clutch Arbor

IMPORTANT: The flywheel spacer, if applicable, must be removed prior to pilot bearing installation.

Install a 5/8 inch washer (1) onto the J 38836 or equivalent.
Install the new pilot bearing (2) onto the tool.

Fig 1: View Of J 38836, Washer & Pilot Bearing (without RPO HP2)

Courtesy of GENERAL MOTORS CORP.

Install the new pilot bearing into the crankshaft using the J 38836 .

Fig 2: Installing Pilot Bearing Using J 38836 (without RPO HP2)

Courtesy of GENERAL MOTORS CORP.

Inspect the clutch pilot bearing for proper installation.

Fig 3: View Of Clutch Pilot Bearing Proper Installation Position (without RPO HP2)

Courtesy of GENERAL MOTORS CORP.